Expand your crafting horizons and master new techniques with the Crafter’s Companion Heat Tool. With this versatile and easy-to-use tool you can create artistic heat-embossed effects and work with moulding foam to make your own stamps! Dry inks and paints in flash, so you have more time to get creative and crafty with your papercraft project. Lightweight for easy handling, the Crafter’s Companion Heat Tool offers two speed settings for optimum control. To get started, simply plug your Heat Tool in and turn it on, then direct the hot-air stream onto your craft project, keeping to a safe distance of 6 inch (15cm). A built-in stand means you can set your heat tool down safely as you work, then when you’re ready to go again simply fold the stand away. When you’re finished, turn off your Heat Tool and wait for it to cool completely before putting away. Once you get started with this versatile tool you’ll find so many amazing uses. You can set watercolours in a specific area of your projet before the colours and effects spread and diffuse further. Use with embossing powders and opaque pigment inkpads to create a glossy, enamelled effect. Or with embossing powder and and watermark inkpads to create a stunning, watermarked effect. And for something extra special, pick up Crafter’s Companion Heat and Mould Stamping Foam to turn just about anything into a stamp. Heat the foam with your Heat Tool, press your design into the foam and voila - a ready-to-use, customised stamp! Voltage: 230v. Power: 300w. Frequency: 50Hz.